PRDW12-4D-IL2 - Long-Distance Cylindrical Inductive Proximity Sensors

Data sheet Print

Data sheet

Installation	Flush
Sensing side diameter	Ø12mm
Sensing distance	4mm
Hysteresis(distance)	Max. 10% of sensing distance
Standard sensing target	12×12×1mm(iron)
Response frequency	500Hz
Indicator	IO-Link mode, SIO mode
Power supply	12 - 24 VDC(ripple P-P: ≤ 10 %), operating voltage: 10 - 30 VDC
Current specification	IO-Link mode: ≤ 25 mA, SIO mode: ≤ 20 mA
Control output	Max. 100mA
Residual voltage	Max. 2V
Protection circuit	Surge protection circuit, output short over current protection circuit, reverse polarity protection circuit
Insulation resistance	≥ 50 MΩ (500 VDC megger)
Dielectric strength	Between the charging part and the case: 1,000 VAC~ 50/60 Hz for 1 minute
Vibration	1.5 mm amplitude at frequency of 10 to 55Hz in each X, Y, Z direction for 2 hours
Shock	500 m/s² (≈ 50 G) in each X, Y, Z direction for 10 times)
Environment_Ambient temperature	-25 to 70 ℃, storage: -25 to 70 ℃ (no freezing or condensation)
Environment_Ambient humidity	35 to 95 %RH, storage: 35 to 95 %RH (no freezing or condensation)
Protection structure	IP67(IEC standard)
Connection	Cable connector type
Connector type	M12 plug connector
Cable Standard/material	Standard type cable (black): polyvinyl chloride (PVC)
Material	Case/Nut: nickel plated brass, washer: nickel plated iron, sensing side: PBT

※The response frequency is the average value. The standard sensing target is used and the width is set as 2 times of the standard sensing target, 1/2 of the sensing distance for the distance.
※In case of SIO mode, use the device within the range where the stable indicator (green) is ON. If the sensing target is in the too close detection distance, the stable indicator turns OFF, but it is in a stable detection state. In case of IO-Link mode, use the device within the range where unstable detection (Byte0_bit6) turns 0. If the sensing target is in the too close detection distance, the too close detection (Byte0_bit5) is 1, but it is a stable detection state.
※Load current of residual voltage: 100 mA, cable length: 2 m
※Ambient temp.: UL approved surrounding air temperature 40 ℃