PRFDAW30-12DP-V-K - Cylindrical Inductive Full-Metal Long-Distance Proximity Sensors (Factor 1 on Fe/Al)

Data sheet Print

Data sheet

Installation	Flush
Sensing side diameter	Ø30mm
Sensing distance	12mm
Hysteresis(distance)	Max. 15% of sensing distance
Standard sensing target	54×54×1mm(iron)
Response frequency	10kHz
Indicator	Stable indicator (green), unstable indicator (orange), Abnormal detect indicator (cross-flashing green, orange)
Unit weight (packaged weight)	≈ 120 g (≈ 180 g)
Power supply	10 - 30 VDC(ripple P-P: ≤ 10 %)
Current specification	Current consumption: Max. 20mA
Control output	Max. 100mA
Residual voltage	≤ 2.5 V
Protection circuit	Surge protection circuit, output short over current protection circuit, reverse polarity protection circuit
Insulation resistance	≥ 50 MΩ (500 VDC megger)
Dielectric strength	Between the charging part and the case: 1,000 VAC~ 50/60 Hz for 1 minute
Vibration	1.5 mm amplitude at frequency of 10 to 55Hz in each X, Y, Z direction for 2 hours
Shock	1,000 m/s² (≈ 100 G) in each X, Y, Z direction for 10 times
Environment_Ambient temperature	-25 to 70 ℃, storage: -25 to 70 ℃ (no freezing or condensation)
Environment_Ambient humidity	35 to 95 %RH, storage: 35 to 95 %RH (no freezing or condensation)
Protection structure	IP66, IP67 (IEC standard)
Connection	Cable connector type
Connector type	M12 plug connector
Cable Standard/material	Oil resistant cable (dark gray)
Material	Case / Nut: stainless steel 303 (SUS303, PTFE coated), rear cap: stainless steel 303 (SUS303), washer: stainless steel 304 (SUS304), sensing side: stainless steel 303 (SUS303, PTFE coated)

※ Use accessories (nut, washer) made of SUS. Or, sensing distance cannot be guaranteed.
※ The response frequency is the average value. The standard sensing target is used and the width is set as 2 times of the standard sensing target, 1/2 of the sensing distance for the distance.
※ UL approved surrounding air temperature 60 ℃
※ Thickness: DIA. of sensing side Ø 12 mm, Ø 18 mm: 0.4 mm / DIA. of sensing side Ø 30 mm: 0.5 mm